A SERVICE OF

logo

32 C3432M-G (4/09)
Service Connector
Figure 23. S ervice Connector
The IP110 Series Camclosure integrated camera system includes a service connector that outputs camera
vide
o. Use it at the installation site to set up the field of view and focus the camera.
Pelco offers two optional items (CST150 and ICS-SC) that plug directly into the service connector. Before
using either option, you must loosen the tamper-resistant screws to remove the trim ring from the back
box. Use the 1/8-inch hollow screwdriver bit (supplied).
The CST150 has a 3-foot (0.9 m) cable and microdisplay fo
r viewing camera video. Plug it into the service
connector and view the video.
NOTE: The three buttons on the CST150 are not used with the IP110 Series Camclosure.
The ICS-SC has a 4-foot (1.2 m) cable with a servic
e connector and a BNC connector. Plug the service
connector into the unit. Then connect the other end to any standard BNC (VIDEO IN) connector on a
monitor.
To assemble a longer service cable for the Camclosure
integrated camera system, purchase the following
items from a local electronics supply store:
Qty Description
1 2.5 mm monaural headphone plug
1 CPM 88 miniature coaxial connector
1 RG174/U coaxial cable
To assemble the cable:
1. Attach the CPM 88 miniature coaxial connector to one
end of the cable. Follow the directions
supplied with the miniature coaxial connector.
2. Attach the 2.5 mm monaural plug to the other end of the coaxial cable (refer to Figure 24):
a. Remove the support sleeve from the plug.
b. Slip the support sleeve over the end of the cable.
c. Prepare the cable.
SERVICE
CONNECTOR