C2635M (1/07) 13
Figure 8. Moving Main Capture Card
INSTALLING THE DX8100 SCSI CARD
The DX8100-ISCI SCSI card is shipped separately. For information about the other DX8100 SCSI kit components, refer to Parts List on page 7. The
SCSI card is installed in the PCI slot 2 on the motherboard.
To Install the DX8100-ISCI SCSI card:
1. Verify that the main Capture Card is installed in slot 3. For information about moving the main Capture Card from slot 2 to slot 3, refer to
Moving the Main Capture Card to Slot 3 on page 12.
2. To install the SCSI card into slot 2, do the following:
a. Firmly seat the DX8100-ISCI SCSI card in the PCI connector for slot 2.
b. Secure the DX8100-ISCI SCSI card bracket with the screw removed from slot 3.
c. Reconnect the 32-pin ribbon cable to the first 32-pin connector (on the main Capture Card) in slot 3.
3. Replace the rear cross-brace.
4. This completes installation of the SCSI card. Next, reassemble the DX8100 and then install the DX9200HDDI. For information about
reassembling the unit, refer to Reassembling the Unit on page 14. For information about installing the DX8100HDDI, refer to Setting Up the
DX9200HDDI on page 15.
Figure 9. Installing the SCSI Card
