C2910M-B-QS (2/06) 5
CONNECTIONS
The CCC5100H Series camera offers standard power and coax video connectors.
To use the RJ45-10 multifunction connector that combines power, video, and control
leads, refer to
Multifunction Connector
in the Installation/Operation manual.
LOW VOLTAGE POWER
Connect 12 VDC or 24 VAC power to the two-pin power connector on the back of the
camera. Use a Class 2 isolated power source for the CCC5100H Series camera that can
supply 12-36 VDC ±10% or 24-28 VAC ±10%, 47-63 Hz.
COAX VIDEO
Connect a video cable to the BNC connector on the back of the camera.
VIDEO FORMAT OVERRIDE
At power-up, the CCC5100H Series camera automatically selects the correct video
format. To manually override the video format selection
•
press and hold the top and center buttons to select NTSC, or
•
press and hold the center and bottom buttons to select PAL.
NOTE:
If using DC power in a PAL installation without Pelco V-Sync, use the two-
button override to select PAL. Otherwise, the camera will default to NTSC.
