C2904M-B (2/05) 67
CONNECTION SCENARIO 3 – USING A CM9760-KBD
Refer to Figure 47 and the instructions that follow.
Figure 47. CM9760KBD Connected to a CM9760-CC1 Controller
1. Connect a PV130 converter to the COM1 port on the back of the NET4001A receiver unit. (For Interface Mode select RS232.) The
data format must be 4800 baud, 8 data bits, even parity, and 1 stop bit.
2. Connect the black and white striped wire from the power supply that comes with the converter to the converter’s +12 VDC terminal
and the solid black wire to the GND terminal.
3. Connect TD(A) on the converter to terminal 7 on the wall block. Connect TD(B) on the converter to terminal 8 on the wall block.
Connect RD(A) on the converter to terminal 2 on the wall block. Connect RD(B) on the converter to terminal 1 on the wall block.
4. Connect an RJ-45 straight cable from the wall block to the power pack.
5. Connect an RJ-45 straight cable from the keyboard input connector on the power pack to COM 1 on the keyboard.
6. Connect the monitor.
7. Refer to Figure 44 and Figure 47. Splice the customer-supplied DB9 cable into the CM9760-CC1 wall block. Connect TX- from the
NET4001A to terminal 2 on the wall block, TX+ to terminal 1, RX- to terminal 7, and RX+ to terminal 8.
8. Plug the DB9 cable into the COM1 port on the transmitter unit. (For Interface Mode select RS232.) The data format must be 4800, 8,
even, 1.
9. Connect an RJ-45 flipped cable from the wall block to Sercom port 5 on the CC1’s rear panel.
10. Connect one of the three monitor outputs on the rear of the controller to the transmitter unit.
Video In Video Out
Audio Out
Audio In
COM1: RS232/485 10/100 Base-T
Ethernet
Power
100-250VAC50/60Hz 100mA
COM2: RS232
Video In Video Out
Audio Out
Audio In
COM1: RS232/485 10/100 Base-T
Ethernet
Power
100-250VAC50/60Hz 100mA
COM2: RS232
PELCONET RECEIVER
PELCONET TRANSMITTER
PV130
TD(A)
TD(B)
RD(A)
RD(B)
GND
+12 VDC
1
2
3
4
8
7
6
5
12 VDC
RD(A)
RD(B)
CM9760KBD
4800, 8, EVEN, 1
STRAIGHT CABLE
12VDC
PV130
TD(A)
TD(B)
RD(A)
RD(B)
GND
+12 VDC
2
3
4
5
6
7
1
8
FLIPPED CABLE
TD(A)
TD(B)
RD(A)
RD(B)
COM IN
STRAIGHT CABLE
TD(A)
TD(B)
CARD CAGE
KEYBOARD
4800
8
EVEN
1
SERCOM PORT
PROGRAMMED
FOR KBD
CM9760-CC1
9750-
