A SERVICE OF

logo

Operating Instructions
[For assistance, please call: 1-800-272-7033] 39
Setup
Connecting the KX-HGW600 to an Ethernet hub
To connect the KX-HGW600 to an Ethernet hub on the LAN (Intranet), follow the steps
below.
1. Connect the Ethernet cable to the WAN jack of the KX-HGW600.
2. Connect the other end of the Ethernet cable to one of the jacks of the Ethernet
hub.
Note
Some Ethernet hubs may have a polarity switch or need category 5 cross cable
instead of category 5 straight cable. Please refer to the Ethernet hub’s manual
for more information.
Ethernet hub
WAN jack
Ethernet cable
(included accessory)