— 10 —
Dip Switch Setting
IMC-101 series DIP switch
Dip Switch 1 (Default: Off )
ON: Enables the PORT Alarm. If the port’s link fails, the
relay will form an open circuit and the fault LED will
light up.
Off: Disables the corresponding PORT Alarm. The relay
will form a closed circuit and the Fault LED will never
light up.
Dip Switch 2 (Default: ON )
ON: Enable full duplex for 100BaseFX
Off: Disables full duplex for 100BaseFX
Dip Switch 3
Reserved for future use
To activate the updated setting of dip switch, you need to power off then
power on the switch.
LED Indicators
The front panel of MOXA Industrial Media Converter contains several
LED indicators. The function of each LED is described in the table
below.
LED Color State Description
On
Power is being supplied to power
input P1
PWR1 AMBER
Off
Power is not being supplied to
power input P1
On
Power is being supplied to power
input P2
PWR2 AMBER
Off
Power is not being supplied to
power input P2
On
When the corresponding PORT
alarm is enabled, and the port’s
link is inactive.
Fault
RED
Off
When the corresponding PORT
alarm is enabled and the port’s
link is active, or when the
corresponding PORT alarm is
disabled.
On
TP port’s 10 Mbps link is active
Blinking
Data is being transmitted at 10
Mbps
10M
GREEN
Off
TP Port’s 10 Mbps link is inactive
On TP port’s 100 Mbps link is active
100M
(TP)
GREEN
Blinking
Data is being transmitted at 100
Mbps
