3. Display position is incorrect.
● Adjust the image position using the
<Position> .
● If the problem persists, use the graphics
board's utility software to change the
display position if available.
4. Screen image is smaller or larger than the actual
screen images.
● Adjust the resolution using the
<Resolution>.
5. Vertical bars of distortion appear.
● Decrease the vertical bars using the
<Clock> .
6. The characters and images have several vertical
bars on their right side.
● If using the monitor in the analog input
signal, try setting the Gamma value from
1.8 to 2.2.
7. Horizontal bars of distortion appear.
● Decrease the horizontal bars using the
<Phase>.
8. Letters and lines appear blurred.
● Adjust the blurred lines using
<Smoothing>.
9. Distortion appears like the figure below.
● This happens when both composite (X-
OR) input signal and separate vertical
synchronizing signal are input. Please
select one of the two.
10. The screen is too bright or too dark.
● Adjust the <Brightness>.
(The backlight of the LCD monitor has a
fixed life span. When the screen becomes
dark or begins to flicker, please contact
your dealer.)
11. Afterimages appear.
● Do you use the screen saver or timer when
displaying the same image for extended
periods of time?
● Afterimages are particular to LCD
monitors. Avoid displaying the same
image for extended periods of time.
