7. Align the depth of the
appliance
To move the appliance further out of
the cabinet:
Loosen screws
c
and tighten
screws
f
.
Tighten screws
c
again to secure it
into position.
To move the appliance further into
the cabinet:
Loosen screws
f
and tighten
screws
c
.
Tighten screws
f
again to secure it
in position.
Check the alignment again by pull-
ing the deflector plate out and push-
ing it back in again.
8 a. Fit side spacers at the
sides of the appliance
(Standard cabinet 23
5
/
8
” (60 cm) wide)
The side spacers cover the gaps be-
tween the sides of the appliance and
the cabinet.
Before fitting the side spacers, use a
knife to make a cut-out in the side
spacer for the appropriate side of
the cabinet to accommodate the
cabinet hinging.
Screw the side spacers to the hous-
ing and press them in at the sides.
Use the 3.5 x 9.5 mm screws.
Note: Please refer to the ”Special instal-
lation instructions” at the end of the ”In-
stallation” section for instructions on in-
stalling the appliance into a 27
9
/
16
”
(70 cm) wide cabinet.
Installation
32
