Please be sure to use the accessories provided by our company to
install this electric water heater. This electric water heater can not
be hung on the support until it has been confirmed to be firm and
reliable. Otherwise, the electric water heater may drop off from the
wall, resulting in damage of the heater, even serious accidents of
injury. When deter-mining the locations of the bolt holes, it shall
be ensured that there is a clearance not less than 0.3m on the right
side of the electric heater, to convenient the maintenance of the
heater, if necessary.
1. This electric water heater shall be installed in the solid wall. If the
strength of the wall can not bear the load equal to two times of the total
weight of the heater filled fully with water, it is necessary to install a
special support.
2. After selecting a proper location, determine the positions of the two
install holes used for expansion bolts with hook (determined according
to the specification of the product you select). Make two holes in the
wall with the corresponding depth by using a chopping bit with the size
matching the expansion bolts attached with the machine, insert the
screws, make the hook upwards, tighten the nuts to fix firmly, and then
hang the electric water heater on it (see Fig.2).
3. Install the supply socket in the wall. The requirements for the socket
are as follows: 250V/10A for 1500W&2000W,and250V/16A for 3000W ,
single phase, three electrodes. It is recommended to place the socket
on the right above the heater. The height of the socket to the ground
shall not be less than 1.8m (see Fig.3).
4. If the bathroom is too small, the heater can be installed at another place
without sun-scorched and rain-drenched. However, in order to reduce
the pipeline heat losses, the installation position of the heater shall be
closed to the location for use of water as near as possible.
Note:
60
100
200
