Troubleshooting
30
Troubleshooting
No lights are displayed when
switching on
❍ Check that your AC power supply is connected correctly.
❍ Check that the ON OFF switch on the back panel is in the ON
position.
❍ Check that the fuse on the compact disc player back panel
and the fuse in the unit’s power plug have not blown; see To
change the mains fuse, page 33.
There is no sound when playing a disc
❍ Check that your preamplifier is switched on, and the volume is
at an appropriate level.
❍ Check that the compact disc player is connected correctly to
the other components of your system; see Connecting the
compact disc player, page 20.
❍ Check that the correct source has been selected on your
preamplifier.
❍ Check that the compact disc player is not paused.
❍ Try playing another disc. If this disc works, check the problem
disc for signs of dirt or damage.
There is interference on the radio and/
or television when the compact disc
player is switched on
Before following the steps below, ensure all units are switched
off.
If this equipment does cause or suffer from interference to/from
radio or television reception then the following measures should
be tried:
❍ Reorient the receiving aerial (or antenna) or route the antenna
cable of the receiver as far as possible from the 588 Compact
Disc Player and its cabling.
❍ Ensure that the receiver uses well-screened antenna cable.
❍ Relocate the receiver with respect to the compact disc player.
❍ Connect the receiver and this product to different AC outlets.
