302
Controls in detail
Loading
ț With the cargo compartment expanded
in part (
୴ page 292), use holders
behind C-pillars 2 and the cargo
tie-down rings in the third-row footwell
(
୴ page 291).
ț With the cargo compartment fully
expanded (
୴ page 293), use holders
behind B-pillars 1 and the cargo
tie-down rings in the second-row
footwell (
୴ page 291).
̈ Open the hook and loop fasteners on
the cargo net package.
̈ Roll out the cargo net.
̈ Unfold the cargo net.
The cargo net bars must audibly
engage.
Installing the cargo net
Cargo net installed behind the B-pillar
1 Holder
2 Cargo net bar
̈ Hang cargo net bar 2 on holder 1 as
indicated by the arrow.
̈ Push cargo net bar 2 forward into
holder 1 in direction of arrow.
Pulling the cargo net tight
Belt hook attached in the second-row
footwell
1 Belt hook
2 Cargo tie-down ring
3 Tightening belt
̈ Hook belt hook 1 into cargo tie-down
ring 2 in direction of arrow.
̈ Pull tightening belt 3 by the loose end
in direction of arrow until the cargo net
is pulled tight.
̈ After driving a short distance, make
sure the cargo net is still tight and, if
necessary, pull it tight again.
