5.0-10 IN-LBS.
5.0-10 IN-LBS.
12-18 IN-LBS.
30-40 IN-LBS.
FIGURE F.16 – DIODE MODULE TIGHTENING SEQUENCE
DIODE MODULE REMOVAL AND REPLACEMENT(CONTINUED)
Refer to Figure F.16.
4. Place a spring washer then a flat washer
over each outer mounting screw and insert
them into the holes. Insert the allen head
screw into the center hole. Tighten all three
screws 2 – 3 turns each, finger-tight only.
(1)
5. Using the torque wrench and 7/16" socket,
tighten the outer screws to between 5.0 and
10 in-lbs. (2)
6. Using the torque wrench and 9/64" allen
head socket, tighten the center screw
between 12 and 18 in-lbs. (3)
7. Now tighten the two outer screws between
30 and 40 in-lbs. (4)
8. Place the negative capacitor strap over the
diode module and align the mounting holes.
Place a lock washer and two flat washers
over each 7/16" screw and insert them into
the holes. Using the torque wrench and
7/16" socket, tighten each screw between
30 and 40 in-lbs.
9. Install the 7/16" bolt, lock washer, flat
washer, heavy lead and negative strap to
the negative terminal on the capacitor.
Tighten the bolt to 50-60 in-lbs.
10. Remove the wooden blocking and careful-
ly lower the tunnel assembly onto the
machine base. Support the tunnel assem-
bly and turn the machine onto its side.
11. With the 3/8" wrench, install the four
screws that hold the tunnel assembly to the
machine base. Turn the machine back
upright.
12. Perform the Case Cover Assembly
Replacement procedure.
