Lifetime 6417 Manual

next previous

TOOLS AND HARDWARE REQUIRED FOR THIS PAGE

SEC

Once all holes have been marked, remove the Floor from the platform and drill out the holes using a hammer drill

ANDvMASONRYBIT/NCEALLHOLESHAVEBEENDRILLEDPOSITIONTHE&LOORAGAINONTHEPLATFORMBEINGSURETO

ALIGNTHEHOLESINTHE&LOORWITHTHEHOLESYOUDRILLEDINTHEPLATFORM9OULLlNISHANCHORINGTHESHEDATTHEENDOF

the instructions. You’ll also ﬁ nd steps at the end of these instructions for anchoring your shed to a wood platform.

Holes are located here.

If you plan on anchoring your shed to your concrete platform, lay your Floor out on your platform in the

position you would like your shed to face. While another person holds the Floor in place, punch out one hole

by each seam and mark the position of that hole on the platform beneath.

TWO PEOPLE REQUIRED FOR THIS STEP

SEC

Note: Pick only one hole by the seam.

Note: Do not use a drill bit or hardware that exceeds 3/8” in diameter.

NO HARDWARE REQUIRED FOR THIS PAGE

2.4

2.5