A SERVICE OF

logo

Repair Information 4-35
4227-X00
Ribbon Drive Motor Assembly Removal
1. Remove the top cover.
See “Top Cover Removal” on page 4-6.
2. Remove the sub logic board.
3. Remove the ribbon drive post cover and the ribbon drive post
[1].
4. Remove the auto gap sensor [2]fromthemotorbracket.
5. Disconnect ribbon motor connector CN19 from the main logic
board.
6. Remove the carrier motor bearing retainer and bearing [3]from
the ribbon motor bracket.
7. Remove the three screws [4] holding the ribbon drive motor
bracket and remove the ribbon drive motor assembly.