Preparation For Taking Pictures
Using An AC Adapter(Opticnal)
Attaching The Wrist Strap
1. Switch off the camera.
2. Make sure the AC adapter is 3.3V/2.0A.
3. Plug the AC adapter into the DC In Connector.
4. Switch on the camera.
Note
Only use the AC adapter (sold seprately) specified for your
camera as use of any other device may result in a breakdown,
fire or electrical shock.
Please refer to the figure 1. 2. 3. below:
1. 2. 3.
Note
1. Do not change the battery with wet hands, as there is a
danger of electric shock.
2. Warning
When you continue using the camera for a long time, the
batteries become hot. Contact with the batteries can lead to
burns.
Never open the battery/card cover while the camera is
accessing the card or processing images.
Do not leave the battery anywhere where the temperature
0 0
may reach 60C (140 F), such as inside a car, in the sun,
near a heater, etc.
Do not get the battery wet, drop it or subject it to violent
shocks.
3.Batteries may lose power if kept inside the camera for a long time
without using. Please remove the batteries while the camera is
not in use.
4. Do not use manganese batteries as they cannot supply sufficient
power to support the camera's operation.
o
5. Batteries may not work normally under 0C.
6. It's normal that the temperature of the camera body rises after
being in use for a long period.
7. It is suggested to use an AC adapter if you expect to use the
camera for a long period.
16
17
Preparation For Taking Pictures
