24 A-61557 December 2006
4. While holding the cleaning card in place, select Scan from the
Kodak ScanTest Software window allowing the entry rollers to scrub
the card.
5. Wait until the motor stops, then remove the card, observing the dirt
and flip the card to a clean corner and repeat Step 4.
To clean the remaining drive rollers:
6. Place the cleaning card in the input tray and select
Scan. You may
need to give the cleaning card a slight push to start it through the
transport.
7. Turn the cleaning card over and repeat Step 6.
8. Scan the cleaning card three or four more times. Be sure that you
continue to turn the cleaning card to a clean side each time you
scan the cleaning card through the transport. Steps 6 through 8
remove the residual dirt on the four drive rollers.
9. When finished, discard the cleaning card and shut down the
Kodak
ScanTest Software.
