Troubleshooting (continued)
Burner(s) will not light
using ignitor.
(See Electronic
Ignition
Troubleshooting also)
Burner(s) will not
match light.
ELECTRONIC IGNITION:
• No spark, no ignition noise.
• No spark, some ignition noise.
• Sparks, but not at electrode or at full
strength.
• See Section I of Electronic Ignition System.
• See Section II of Electronic Ignition System.
• See Section III of Electronic Ignition System.
• See "GAS ISSUES:" on previous • Use long-stem match (fireplace match).
page. • See "Match-Lighting" section of Use and Care.
• Match wiii not reach.
• Improper method of mafch-iighfing.
• Check for gas in LPcylinder.
• Out of gas.
• Excess flow valve tripped.
• Vapor lock at coupling nut/LP
cylinder connection.
Suddendrop ingas
flow or tow flame.
Flames blow out.
Flare-up.
Persistent grease fire.
•Turn off knobs, wait 30 seconds and light grill. If flames are
still low, turn off knobs and LPcylinder valve. Disconnect
regulator. Reconnect regulator and leak-test. Turn on LP
cylinder valve, wait 30 seconds and then light grill.
•Turn off knobs and LPcylinder valve. Disconnect coupling nut
from cylinder. Reconnect and retry.
• High or gusting winds.
• Low on LPgas.
• Excess flow valve tripped.
• Grease buildup.
• Excessive fat in meat.
• Excessive cooking temperature.
• Grease trapped by food buildup
around burner system.
Flashback... • Burner and/or burner tubes are
(fire in burner tube(s)) blocked.
• Turn front of griii to face wind or increase flame height.
• Refill LPcylinder.
• Refer to "Sudden drop in gas flow" above.
• Clean burners and inside of grili/firebox.
• Trim fat from meat before grilling.
• Adjust (lower) temperature accordingly.
•Turn knobs to OFF. Turn gas off at LPcylinder. Leave lid in
position and let fire burn out. After grill cools, remove and
clean ait parts.
• Turn knobs to OFF. Clean burner and/or burner tubes. See
burner cleaning section of Use and Care.
Unable to fill LP • Some dealers have older fiiI nozzles • The worn nozzles don't have enough "bite" to engage the
cylinder, with worn threads, valve. Try a second LPdealer.
One burner does • Grease buildup or food particles in • Clean carry-over tube (s)with wire brush.
not light from end (s) of carryover tube (s).
other burner (s).
16153- 50300312 _ 27
