70
To use the stored signals
When you want to use the stored signals, follow the procedure
below.
1. Set the LEARN/TRANSMIT selector
to “TRANSMIT.”
2. Press one of the source selecting buttons (or
CONTROL repeatedly) to select the desired
remote control operation mode (source).
3. Press the desired button.
Notes:
• To operate the TV, CATV tuner, or DBS tuner, set the TV operation
mode selector correctly.
• To use the following buttons, you can skip step 2 above.
– TV/DBS , VCR 1 , TV VOL +/–, TV/VIDEO, DVD MENU
• To use the following buttons, press DVD MENU first.
– SET,
%
/
fi
/
@
/
#
IMPORTANT:
To operate the other component(s) using this remote control—
• Aim directly at the remote sensor(s) on the target component(s).
–This remote control can send signals at a distance of 7 m.
\
and
To erase the stored signals
After erasing the stored signals, preset signals are resumed and you
can operate JVC’s components again.
1. Set the LEARN/TRANSMIT selector
to “LEARN.”
2. Press and hold EXIT, then press one of the source
selecting buttons from which you want to erase
the stored signals.
“CLEAR” appears on the display, and all the signals stored in
the selected remote mode (source) are erased at the same time.
Notes:
• You cannot erase a signal assigned to a particular button only.
Storing a new signal to a particular button erases the previously
stored signal.
• To erase the stored signals for “CD DISC,” first press
CONTROL to select “CD DISC,” then press CONTROL again
while holding EXIT this time.
3. Set the LEARN/TRANSMIT selector to
“TRANSMIT” to finish the erasing procedure.
and
DVD
DVD MULTI
CD
CDR
PHONO
TAPE/MD
EXT 7.1CH
VCR 1 VCR 2
FM/AMVIDEOTV/DBS
DVD
DVD MULTI
CD
CDR
PHONO
TAPE/MD
EXT 7.1CH
VCR 1 VCR 2
FM/AMVIDEOTV/DBS
CHANNEL
TV/VIDEO
EFFECT
LIVENESS
FM MODE
RETURN
100
+
SET
DVD
MENU
123
456
7
/P
89
10
+
100
TV VOL
TV/DBS
VCR 1
REC
STOP PAUSE
FF/
/ REW
PLAY
PTY SEARCH
DISPALY MODE
TA/NEWS/INFO
PTY( PTY9
EN61-74_RX-DP20VSL[B]f.pm5 03.5.21, 19:0870
