Page 21
English
Assigning Names to Preset Stations
You can assign a name of up to five characters to each preset station (from preset channel number 1 to 20).
When a preset station is tuned in, its assigned name will appear on the display.
On the front panel only:
1. Tune in a preset station (preset channel number 1 to 20).
See page 20 for details.
2. Press MEMORY (next to the TUNER button).
The preset channel number starts flashing.
Note:
If you press Control
%
/
fi
while the preset
channel number is flashing, you can change the
preset channel number.
3. Press Control
##
##
# (or
@@
@@
@) until the first character
position starts flashing.
4. Press Control
%%
%%
% /
fifi
fifi
fi to select a character.
You can use the characters listed below.
5. When a character you want appears, press
Control
##
##
# (or
@@
@@
@).
The next (or previous) character position starts
flashing.
6. Repeat steps 4 and 5 to enter up to five characters.
7. Press MEMORY (next to the TUNER button) again, while the last selected character is
flashing, after you have assigned a name.
To erase the input characters
Insert blanks using the same procedure described above.
Available characters
Blank
Front panel
MEMORYTUNER
MEMORYTUNER
CBADEGFHIJKLMNO
SRQTUWVX
Y
Z01234P
87695
RX-630RBK[EF]0055-001A.En.01-27 97.7.25, 5:24 PM21
