Continued on Next Page
SB-GM-TAHOSCNSL/10W3v2_INSTR_SKU#011220
SB-GM-TAHOSCNSL/10W3v2_INSTR_SKU#011220
STEP 21B
This is the passenger’s side tab.
STEP 21A
The rear of the Stealthbox® is to be fitted between a pair of
tabs that are protruding up from the flooring.
This is the driver’s side tab.
STEP 20
The front of the Stealthbox® fits against the black plastic
panel located on the passenger side.
STEP 19
Position the Stealthbox
®
in the mounting location.
Page 4 • JL Audio, Inc 2006
STEP 23
Note: Before drilling, make sure that you are not going
to be drilling into any gas lines, brake lines, transmission
lines, electrical wiring, transfer case (4x4 vehicles)
or anything else that might cause a reduction in your
weekly pay. Always wear eye protection when drilling!
With a drill and a 1/2-inch drill bit, drill through the
impression made in the wax square and into the vehicle’s
transmission tunnel.
Remove the wax squares and the tape.
STEP 25
Place the Stealthbox
®
into position by guiding the socket
cup set screws through the holes drilled in Step 23.
STEP 24
Run speaker wire from the amplifier’s location to the
Stealthbox
®
location and check for proper operation of
the woofer.
Back out the socket cup set screws installed in Step 18, to
expose 1 1/4-inch.
STEP 22
Once the Stealthbox
®
is in the mounting location, press
down on it firmly.
Remove the Stealthbox
®
carefully, leaving the wax squares
in place. The socket cup set screws will leave impressions in
the wax.
