11
4. Remove the 2 screws that mount the motor mounting bracket
to the vent box. Remove the blower motor and mounting
bracket assembly from the vent box.
5. Remove the 4 screws from the small cover plate on the rear
of the vent chamber and set screws and cover plate aside.
6. Install blower motor and mounting bracket assembly to the
bracket just below the downdraft tower motor. The blower
exhaust opening should fit through the hole in the large cover
plate on the opposite side of the vent chamber where the
small cover plate was removed. Replace the 2 blower motor
mounting bracket screws and tighten.
7. Plug in the wire connector to the blower motor.
8. Place the vent extension for the 6" diameter venting over the
vent exhaust and screw into place using the 4 screws.
9. Replace the vent box over the blower motor.
A. Blower motor mounting bracket screws (2)
A. Downdraft tower motor
B. Large cover plate
C. Blower exhaust opening
A
A
A
B
C
A. Blower motor
B. Wire connector
A. Vent extension screws (4)
A. Blower motor
B. Vent box
A
B
A
A
A
B