23
Door Sensor
Model: 2845-222
Door Sensor
Model: 2845-222
Door Sensor
Model: 2845-222
Software-Only Features
Enable Group 1 & 2 Broadcast Disable Local Programming
Disable LED and Beeper Adjust Heartbeat Interval
When enabled, Door Sensor will send a
separate On for opening and for closing.
Useful if you want a device to turn on when
the door closes, like a bathroom fan.
Prevents changing any settings using the set
button or tap-and-hold programming.
The status LED will not blink when the
sensor is triggered and the beeper will not
respond to button presses.
Customize the duration of time between
sensor check-ins; by default, the sensor will
broadcast it’s state once every 24 hours.
$
RADIO
RADIO
SMOKE AND CARBON
MONOXIDE ALARM
a
1:30
iOS
MANUAL
INSTEON
Quick Start Guide
INSTEON
Owner’s Manual
This device complies with FCC
Rules and Industry Canada
license-exempt RSS standard(s).
Operation is subject to the
following two conditions: (1) this
device may not cause harmful
interference, and (2) this device
must accept any interference,
including interference that may
cause undesired operation of
the device.
This device complies with FCC
Rules and Industry Canada
license-exempt RSS standard(s).
Operation is subject to the
following two conditions: (1) this
device may not cause harmful
interference, and (2) this device
must accept any interference,
including interference that may
cause undesired operation of
the device.
INSTEON
Documentation
720P
BUSINESS REPLY MAIL
ATTN: INSTEON
16542 MILLIKAN AVE
IRVINE CA 92606
ALWAYS ON
Group 1 ON Group 2 ON
