10
• The base is attached via 4 screws that can be found on the back of the TV directly above the base.
o Lay the TV face down on the edge of a table or work bench. Make sure to put your TV on a cushion or soft
covering to prevent damaging the case or screen.
o Remove the 4 screws that secure the stand column to your TV.
o Slide the stand away of the TV.
How do I get headphones to work with my TV?
• Connect the headphones cable to the headphone jack on the side of your TV.
• A headphone icon will appear in the upper right corner of the screen.
• Sound will only be heard through the headphones when they are plugged in.
• Use the volume buttons on the remote to adjust the volume level.
• To hear sound again through the TV speaker, unplug the headphones. A speaker symbol will appear in the upper right
corner of the screen.
Can I get an additional remote?
• Additional remotes can be purchased from Parts. Please call support at 877-467-4289, where an agent can transfer
you to PartSearch.
How do I program my clock/time?
• Press MENU. The on-screen menu opens.
• Press ^ or v to select Feature, then press > to enter Feature menu.
• Press ^ or v to select Time Set, then press ENTER to enter Time Set adjustment menu.
• Press ^ or v to select Time Set Mode, then press > to choose from: Manual or Auto.
o If you choose Manual, you can manually set the clock on your TV.
Press ^ or v to select Time Zone, then press > to choose from: Pacific, Alaska, Hawaii, Eastern,
Central, or Mountain.
Press ^ or v to select Time, then press < or > to set the time.
o If you choose Auto, the TV will automatically set the time based on the digital or cable signal received.
Press ^ or v to select Time Zone, then press > to choose from: Pacific, Alaska, Hawaii, Eastern,
Central, or Mountain.
• Press EXIT when you are finished.
Nothing happens when I push buttons on my remote.
• Make sure the TV is plugged in.
• The supplied batteries are wrapped tightly in clear plastic. Have you removed the plastic from the batteries before you
installed them?
• Are the batteries installed correctly?
o Remove the battery compartment cover on the back of the remote control.
o Insert the two AAA batteries into the battery compartment. Make sure that the + and – on the batteries align
with the + and – symbols in the battery compartment.
o Replace the battery compartment cover.
• Point the control directly at the remote sensor on your TV. The remote sensor is located below the Insignia logo on your
TV.
• Remove any obstacles between the remote control and the remote sensor.
• Replace dead batteries with new ones.
