24
4
r PLOTTER MODEq MARK MANIPULATION
(4)-1 Registering marks
Å Registration of marks from the
Plotter Menu screen
Navigational reference points, such as the destination point and turning
points, can be indicated with marks. These marks will be helpful for desti-
nation navigation and route navigation.
They can be registered in two ways: from the Plotter Menu screen or on the coast-
line screen.
q Press the [MENU] key.
The Main Menu screen will appear.
w Select “Plotter Menu” using the [UP] or [DOWN] key and press the [SET] key.
The Plotter Menu screen will appear.
e Select “Mark Enter/Erase” using the [UP] or [DOWN] key and press the [SET]
key.
The Mark Enter/Erase screen will appear.
r Select “ENTER” using the [UP] or [DOWN] key and press the [SET] key.
The system is ready for mark registration and the first digit of the latitude setting
field is highlighted in yellow.
t Select digits in the latitude setting field using the [LEFT] or [RIGHT] key, enter a
numerical value and specify the latitude direction, N (North) or S (South), using
the [UP] or [DOWN] key, and then press the [SET] key.
The first digit of the longitude setting field is highlighted in yellow.
y Select digits in the longitude setting field using the [LEFT] or [RIGHT] key, enter
a numerical value and specify the longitude direction, E (East) or W (West),
using the [UP] or [DOWN] key, and then press the [SET] key.
One of 12 marks will appear at the bottom of the screen.
u Select the desired mark using the [UP] or [DOWN] key and the desired color of
the mark (seven colors selectable) using the [LEFT] or [RIGHT] key, and then
press the [SET] key.
The character list will appear at the bottom of the screen and END is highlight-
ed in yellow.
i Select a character from the character list to name the mark, and then press the
[SET] key.
Each time the [SET] key is pressed, the selected character is entered in the
comment field.
* A comment such as a user-defined mark name of up to eight characters can be
entered in each comment field.
o Select “END” and press the [SET] key.
The mark is now registered.
* Repeat steps t to o as required.
