4 - 34
1. Seat the D9 connector firmly over the USB Connector on the Quick Mount Smart Dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB-host connector provides a connector for a USB device such as a USB thumb drive.
4. Secure the cables to the Thor VM1 with Strain Relief Cable Clamps (page 4-13).
Connect USB Client
See USB Connector (page 10-5) for connector pinouts.
1. Seat the D9 connector firmly over the USB Connector on the Quick Mount Smart Dock.
2. Tighten the thumbscrews in a clockwise direction. Do not over tighten.
3. The USB client connector provides a client connection, such as for ActiveSync to a PC.
4. Secure the cables to the Thor VM1 with Strain Relief Cable Clamps (page 4-13).
Connect Serial Device
Note: Pin 9 of the desired COM port must be configured to provide +5V or RI as needed for the connected device. See the
Thor VM1 Reference Guide for details.
See COM1 and COM2 Connector (page 10-4) for connector pinouts.
1. Seat the cable end connector firmly over the serial COM port on the Quick Mount Smart Dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Secure the cables to the Thor VM1 with Strain Relief Cable Clamps (page 4-13).
4. Connect the other cable end to the desired serial device.
D9 Connector
USB Host Connector
USB Client Connector
