VI. Mainsheet Assembly
Locate mainsheet (part #16). Take one end of
the mainsheet and tie it to the small block
hanging at the rear of the boom with a bowline
(Figure 18). Run the free end through the large
r block of the traveler block set and then back up
to and through the .small block hanging at the
rear of the boom.
ยป
Fig. 16
Fig. 18
Now run the free end of the mainsheet for-
ward along the boom. Run the line through the
~ circular strap attached to the boom and then
run the line through the block attached to the
~ boom just forward of the strap.
. Fig 17 Continue the line forward and then down
. through the mainsheet block (part #32) at-
tached to the bottom of the hull behind the
mast and the daggerboard slot. Tie the free end
of the line in a figure 8 knot about 6 inches
from the end. Shown, Figure 19.
~:::j
~
.. Fig. 19
-8-
