Hard drive
NOTE: The hard drive spare part kit includes a hard drive bracket, hard drive connector, and Mylar
cover.
Description Spare part number
500-GB, 5400-rpm 506058-001
400-GB, 5400-rpm 506057-001
320-GB, 5400-rpm 506056-001
250-GB, 7200-rpm 519190-001
250-GB, 5400-rpm 506055-001
160-GB, 5400-rpm 506054-001
Hard Drive Hardware Kit (includes hard drive bracket, hard drive connector, and
hard drive screws)
497744-001
Before removing the hard drive, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power cord.
4. Remove the battery (see
Battery on page 35).
Remove the hard drive:
1. Position the computer with the front toward you.
2. Loosen the two Phillips PM2.0×5.0 captive screws (1) that secure the hard drive cover to
the computer.
3. Lift the left side of the hard drive cover (2) and swing it to right.
Component replacement procedures 37
