A SERVICE OF

logo

Open as PDF
next previous
Example B-2 CA Command
CC Command
CC - Complex Configuration
• Access level—Administrator
• Scope—Complex
This command performs an initial out-of-the-box complex configuration. The system can be
configured as either a single (user specified) cell in partition 0 (the genesis complex profile) or
the last profile can be restored. The state of the complex prior to command execution has no
bearing on the changes to the configuration. You must ensure that all other partitions are shut
down before using this command. You might need to run the ID command after you create a
genesis complex profile. If the genesis profile is selected, then all remaining cells are assigned to
the free cell list.
150 Management Processor Commands