A SERVICE OF

logo

6. Lift the hard drive (4) up and slide it out of the drive bay.
Reverse this procedure to install the hard drive.
To remove the solid-state drive:
1. Release the ZIF connector (1) to which the SIM card cable is attached. The end of the cable lies
across the top of the solid-state drive.
2. Disconnect the SIM card cable (2), and then detach the tape from the top of the solid-state drive.
3. Release the LIF connector (1) to which the solid-state drive cable is attached.
4. Disconnect the solid-state drive cable (2).
5. Remove the two Phillips PM2.0×4.5 screws (3) that secure the drive bracket to the device.
Component replacement procedures 43