A SERVICE OF

logo

Open as PDF
next previous
You can configure the event or action that controls the onset of each
sweep through the scan list (a sweep is one pass through the scan list):
• You can set the instrument’s internal timer to automatically scan at
a specific interval as shown below. You can also program a time delay
between channels in the scan list.
• You can manually control a scan by repeatedly pressing from
the front panel.
• You can start a scan by sending a software command from the
remote interface.
• You can start a scan when an external
TTL trigger pulse is received.
• You can start a scan when an alarm condition is logged on the
channel being monitored.
Scan List (1 sweep)
t
Scan-to-Scan Interval
(0 to 99:59:59 hours)
Scan Count
(1 to 50,000 scans, or continuous)
3
Chapter 3 System Overview
Measurement Input
63