A SERVICE OF

logo

3.
Disconnect all external devices from the computer.
4. Remove the battery (see
Battery on page 33), and then remove the following components:
a.
Solid-state drive connector board cable (see
Solid-state drive on page 35)
b. Card Reader board cable (see
Card Reader board cable on page 37)
c. Top cover (see
Top cover on page 40)
Remove the power button board:
1. Turn the top cover upside down, with the front toward you.
2. Remove the Phillips PM2.0×3.6 screw (1) that secures the power button board to the top cover.
3. Remove the power button board (2) and cable.
Reverse this procedure to install the power button board.
Component replacement procedures
47