13.
If it is necessary to replace the display enclosure or any of the display assembly internal
components:
a. Remove the Mylar screw covers (1). The screw covers are included in the Display
Miscellaneous Kit, spare part number 603659-001.
b. Remove the two Phillips PM2.5×7.0 screws (2) that secure the display enclosure to the
display assembly.
c. Remove the hinge covers (3). The hinge covers are available using spare part number
603666-001.
d.
Turn the display assembly upside down, with the hinges toward you.
e. Lift the bottom edge of the display bezel/panel assembly (1) until it rests at an angle.
f. Disconnect the logo light cable (2) from the display panel cable.
g. Remove the display bezel/panel assembly (3).
14.
If it is necessary to replace the webcam/microphone module:
a. Remove the Phillips PM2.0×4.0 screw (1) that secures the webcam/microphone module to
the display bezel.
b. Release the webcam/microphone module (2) as far as the webcam/microphone
module allows.
70 Chapter 4 Removal and replacement procedures
