5–10 Maintenance and Service Guide
Computer Setup
Diagnostics menu
System Configuration menu
✎
Some of the listed System Configuration options may not be supported by your computer.
Select To do this
System Diagnostics menu ■ F1 System Information—Displays the
following information:
❐ Identification information for the computer and the
batteries in the system.
❐ Specification information for the processor, memory
size, system ROM, video revision, keyboard controller
version, and wireless identification numbers.
■ F2 Start-up Test—Verifies the system components needed
for starting the computer.
■ F3 Run-In Test—Runs a comprehensive check on
system memory.
■ F4 Hard Disk Test—Runs a comprehensive self-test on
any hard drive in the system.
■ F5 Error Log—Displays a log file if any errors
have occurred.
Select To do this
Language Change the Computer Setup language.
Boot Options ■ Set a Startup Menu delay (in seconds).
■ Enable/disable Custom Logo (disabled by default).
■ Enable/disable Display Diagnostic URL (enabled
by default).
■ Enable/disable CD-ROM boot (enabled by default).
■ Enable/disable SD Card boot (enabled by default).
■ Enable/disable floppy boot (enabled by default).
■ Enable/disable PXE Internal NIC boot (enabled by default).
■ Set the Express Boot Popup delay in seconds.
■ Set the boot order.
Device Configurations ■ Enable/disable USB legacy support (enabled by default).
When enabled, USB legacy support allows the following:
❐ Use of a USB keyboard in Computer Setup even when a
Windows operating system is not running.
❐ Startup from bootable USB devices, including a hard
drive, diskette drive, or optical drive connected by a USB
port to the computer.
■ Select a parallel port mode: ECP (Enhanced Capabilities
Port), standard, bidirectional, or EPP (Enhanced
Parallel Port).
■ Enable/disable fan always on while connected to an AC
outlet (enabled by default).
(Continued)
