IPv6 Management Features
Telnet6 Operation
Viewing the Current Telnet Activity on a Switch
Syntax:
show telnet
This command shows the active incoming and outgoing telnet
sessions on the switch (for both IPv4 and IPv6). Command
output includes the following:
Session: The session number. The switch allows one outbound
session and up to five inbound sessions.
Privilege: Manager or Operator.
From: Console (for outbound sessions) or the source IP address
of the inbound session.
To: The destination of the outbound session, if in use.
For example, the following figure shows that the switch is running one
outbound, IPv4 session and is being accessed by two inbound sessions.
ProCurve# show telnet
Telnet Activity
------------------------------------------------------- -
Session : 1
Privilege: Manager
From : Console
To : 10.0.10.140
------------------------------------------------------- -
Session : 2
Privilege: Manager
From : 2620:0:260:212::2:219
To :
------------------------------------------------------- -
Session : ** 3
Privilege: Manager
The ** in the “Session: indicates the
From : fe80::2:101
session through which show telnet was
run.
To :
Figure 5-4. Example of Show Telnet Output with Three Sessions Active
5-7
