4. Install the Switch Hardware (Continued)
M-4 tap
screws
Ventilation
Wall (or Under-Table):
A special kit for wall-mounting (or
under-table mounting) is included. Use a #1 Phillips (cross-
head) screwdriver and the 20-mm M4 tap screws (included).
For screw positions, see the mounting template on page 4.
(Under-Table: After installation, a third screw
may be used to
prevent switch movement.)
For wall-mounting, the network ports may face up or down.
Do not
mount the switch with ventilation ducts facing up or
down. (See “Safety Precautions” on page 3.)
Rack Mounting: A speci
al rack-mounting kit is included. Use a #1 Phillips (cross-head) screwdriver to attach the special
brackets to the switch using the eight 8-mm M4 screws. Then use the four number 12-24 screws to secure the brackets to the
rack.
5. (Optional) Lock the Switch. Use a Kensington lock or
similar device (not included) to physically secure the switch.
6. Power On the Switch.
Use the cable tie strap to secure the connection.
7. Connect Network Cables.
2
QSG-1410-16G-Feb2010.fm Page 2 Thursday, February 25, 2010 7:45 PM
