A SERVICE OF

logo

Open as PDF
next previous
-6-
598-1172-04
Note: Some models might require the use of
tweezerstoremoveandreplacethejumpers.
3. Tochangethecode,either:
• Addajumpertothesamelocationonboththepushbuttonandthechimeor...
• Removeajumperfromthesamelocationonboththepushbuttonandthechimeor...
• Moveajumperonthepushbuttonfromonelocationtoanother.Movethecorresponding
jumperonthechimetomatchthenewlocationinthepushbutton.
Example: Move jumper at location “5” to location “4” on both the push button and the
chime.
Note:

Note:Unitwillcomefactorysetwithjumpersinlocations5,6,and7onthepushbuttonand
onthechime(seeFigure10).
Therangeofthewirelesschimecanvarywithlocation,temperature,andbatterycondition.
Figure 10
TYPE “D”
TYPE “D”
TYPE “D”
1 2 3 4 5 6 7 8
VOLUME
12345678
Inside Push Button
FrontofChimeBase
* Code Settings 1-7
Must Match Both Push
Button and Chime