174-082010_Digital AVC Page 5 of 17
1.3 Compliance data
1.4 Safety
The following symbols and terms may be found on THI products and/or in THI manuals and indicate
important information.
When found on the device, this symbol indicates that the operator should refer to the manual for
important instructions on the proper use of this device. When found in a manual, this symbol
indicates that the reader should understand the implications contained in the text before
operating the device.
The WARNING label indicates important information that should be heeded for safe and proper
performance of the device.
The label, CAUTION, is used to indicate that damage to the power supply or equipment connected to it,
could occur if directions are not followed. Warranty could be invalidated if the instructions in this manual are
not followed.
Accessories
1.4.1 Installation Accessories
THI offers a complete line of system attachments that
permit easy maintenance for contaminated operations.
Gauge tubes are offered with various system fittings to
match almost any system requirement. Additionally,
THI’s complete line of quick disconnect attachments
allows customers to install these special fittings and
easily replace sensors without vacuum sealant or
Teflon® tape. For particularly dirty systems, Hastings
offers a particle dropout trap containing a series of nine
separate baffles which prevent solid contaminants from
having a direct path to the sensor’s thermopile.
1.4.2 DV-6S: New DV-6 tube For Severe
Environments
Hastings Instruments has developed a new gauge tube, the DV-6S, which is specifically designed for
outdoor use on cryogenic tanks including railcar and tanker truck applications. In addition to the DAVC, the
gauge tube is compatible with the hand-held HPM-4/6 and the analog VT-6.
The DV-6S is supplied with a protective cap. The o-ring-sealed cap protects the gauge tube pins from
moisture thus significantly reducing corrosion. A metal lanyard prevents cap loss. The tube is provided with
a standard 1/8” NPT fitting; however special fitting requests can often be met.
CE Standard Compliance
Test Standard
SAFETY EN61010
EMC/EMI Family EN61326
CONDUCTED/RADIATED EN55011
ESD EN61000-4-2
RF EN61000-4-3
CONDUCTED IMMUNITY EN61000-4-6
