A SERVICE OF

logo

TM
Assembly
Windshield
Handlebar
Assembly
Retainer
Handlebar
Harness
• Position the handlebar assembly face down.
• Position the windshield curved side down.
• Slide the windshield down over the headlight assembly.
• Insert four #8 x
3
/
4" screws through the front fork and
into the windshield. Tighten screws using a Phillips
screwdriver. Do not over-tighten.
• Loop the handlebar harness
around the retainer in the neck
of the vehicle frame.
• Fit the remaining steering bushing on top of the neck of
the vehicle frame.
• Insert two #8 x
3
/4" screws through each side of the
steering bushing and into the neck. Tighten screws using
a Phillips screwdriver. Do not over-tighten.
Steering
Bushing
See
Inset
Retainer
Handlebar
Harness
• Fit the handlebar harness plug
up through the rectangular hole
in the vehicle body.
TM
Handlebar
Harness Plug
Rectangular Hole
T
M
See
Inset
Handlebar
Harness Plug
Rectangular Hole
20
36
37
38
39