To install the drill chuck:
1.
2.
3.
Note: While it may not seem like there is
anything keeping the drill chuck in place, the
Jacob’s Taper fit provides a strong bond and
will hold the drill chuck tightly Figure 14
Figure 14.
Drill Chuck Arbor Face Mill
To install the face mill:
1.
2.
Figure 15
Figure 15.
3.
4.
Collet/Arbor Page 20.
All types of milling cutters and drill bits are
sharp. It is recommended that these not
be handled directly. Use leather gloves or
shop towels to hold sharp tooling to avoid
cuts to your hands. Be careful while han-
dling them and store them in a child safe
location.
