106
www.gateway.com
■ If you do not know the password, you may need to reinstall the software you are trying
to access.
■ System startup passwords are stored in BIOS. If this password has been set and you
do not know it, you may be able to reset the password through system board jumper
settings. For instructions, see “Resetting BIOS passwords” on page 98.
Memory errors were detected while the system started up
■ See “Memory errors were detected during server start up” on page 120 for a possible
solution.
Memory size error
■ Restart your server, then open the BIOS Setup utility by pressing and holding F2 while
your server restarts. Save the memory configuration.
Missing operating system
■ The master boot record may be corrupt. For troubleshooting information, see “The
master boot record is corrupted” on page 120.
System Event Log Full
■ Clear the event log. To clear the event log, restart your server, then open the BIOS
Setup utility by pressing and holding F2 while your server restarts. Select the
Server
menu, then select the
Event Log Configuration menu.
