68
4.15
Network Setting
The following is an explanation of network setting.
There are 2 methods of setting the network as shown below.
● Set it by using the operation panel of PG4500N.
● Set it by installing the setting software on the connected host (PC).
4.15.1 Setting Using the Operation Panel
1
.
Press the ONLINE key on the operation panel to switch
the machine to OFFLINE condition.
2
.
When the machine is in OFFLINE mode, press the NEXT
key four times.
★ The message changes to "Network Setting".
3
.
Press the SEL key.
★ When the password is set, go to Procedure 4, and when
it is not set, go to Procedure 5.
4
.
Input the set password.
★ If the password is not correct, a "Failed to verify the
Password" message appears, so press the [ESC] key
and redo from Procedure 2.
5
.
Screen for setting TCP/IP opens. In the case of "Enable",
go to Procedure 5, and in the case of "Disable", go to
Procedure 13.
Network Setting
ESC
PREV
SEL
NEXT
ESC
PREV
SEL
NEXT
Password
0000
[
]
[
]
–
+
Failed Verify
the Password
TCP/IP
[ ]
Enable
+
[ ]
–
TCP/IP
[ ]
Disable
+
[ ]
–
ESC
PREV
SEL
NEXT
