A SERVICE OF

logo

Open as PDF
next previous
7
3. Attach the Post (F) to the Post Supports (G). Once you
have tightened the bolts holding the Post Supports (G) to the Base (H),
align the holes in the Post (F) with the holes on the tops
of the Post Supports (G) and insert a M6x35 (CC) bolt through a M6 (HH)
washer and then through the hole in the Post Support. Affix another
M6 (HH) washer onto the bottom of the M6x35 (CC) bolt and secure with a
M6 (DD) nut. Repeat this in the 5 remaining holes (6 holes total—2 for
each Post Support piece). Hand tighten initially then tighten with a
wrench when all bolts have been inserted.
Hardware Used: 6 x CC, Bolt M6x35
12 x HH, Washer M6
6 x DD, Nut M6
4. Place Tank Housing (C) onto Base (H). Slide Tank Housing (C) over
the Post and down over the Post Supports.
Rest Tank Housing on Base.
ASSEMBLY
3
4