- 8 -
4. Place Cylinder Housing onto Post. Slide Cylinder Housing down over
Support Brackets and Post and rest on Base.
5. Attach Reflector Studs to Screen Cover. Insert 3 Reflector Studs through
washers and into holes on screen cover. Tighten studs securely.
Hardware Used:
3 Reflector Studs 3 Large Flat Washers
6. Attach Head Assembly to Post. Unscrew 4 Small Bolts and 4 Lock Washers
pre-assembled in the Head Assembly. Route
Gas Hose down into post and then place
Head Assembly on top of Post.
Note: Control knob should be above the decal
on Post.
Attach Head Assembly to Post by inserting
bolts through lock washers and into holes on
Head Assembly and Post. Once all bolts and
lock washers have been inserted, tighten securely.
Hardware Used:
4 Small Bolts 4 Lock Washers
