FS-8700-133 Genisys Manual Page 8 of 13
FieldServer Technologies 1991 Tarob Court Milpitas, California 95035 USA Web: www.fieldserver.com
Tel: (408) 262 2299 Fax: (408) 262 2269 Toll Free: (888) 509 1970 email: support@fieldserver.com
4.4 Client Side Map Descriptors
4.4.1 FieldServer Related Map Descriptor Parameters
Name of this Map Descriptor
Up to 32 alphanumeric characters
Name of Data Array where data is to be
stored in the FieldServer
One of the Data Array names from “Data
Array” section above
Starting location in Data Array
0 to maximum specified in “Data Array”
section above
Function of Client Map Descriptor
COS_Poller, COS_Read , Wrbx
4.4.2 Driver Related Map Descriptor Parameters
Name of Node to fetch data from
One of the Node names
specified in “Client Node
Descriptor” above
‘Bit’ each byte of Indication statuses will be stored in 8 consecutive
locations in the Data Array. Similarly while writing; Control byte
will be composed from 8 consecutive locations of the Dara Array.
‘Byte’ each byte of Indication statuses will be stored as an 8-Bit
Integer at the specified location. Similarly while writing; Control
byte will be composed from a single location of the Data Array.
Refer to Appendix A.1
Internally used parameter, if used specify value 0
Length of Map Descriptor
Number of indications to store or number of controls to write as
per Data_Type.
Bit: 1-256, 8
Byte: 1-32, 1
4.4.3 Timing Parameters
Rate at which data is polled
