380224 Ver. 1.5 5/05
3
Front Panel Description
1. LCD Display
2. Rotary Select Switch
3. ‘F’ (Farad) Capacitance input jack
4. ‘T’ input jack
5. Rubber Holster
6. COM and ‘S’ input jack
7. Voltage, Resistance, ‘R’, Hz,
and Temperature input jack
Preparation for measurement
Safety Information
The following information must be observed to insure maximum personal safety while
operating this meter.
1. Do not use the meter if the meter/test leads appear damaged or if you suspect that
the meter is not operating properly.
2. The user should never be grounded when taking measurements. Do not touch
exposed metal pipes, outlets, fixtures, etc. which may be at ground potential. The
user should be isolated from ground by using dry clothing, rubber soled shoes,
rubber mats, or other approved insulating material.
3. Remove power to the circuit under test before cutting, unsoldering, or breaking the
circuit. Small amounts of current can be dangerous.
4. Use caution when working above 60V DC or 30V AC rms. Such voltages pose a
shock hazard.
5. When using the test leads or probes, keep fingers behind the probe's finger guard.
6. Measuring voltage which exceeds the limits of the multimeter may damage the meter
and endanger the user. Always recognize the meter's limits as stated on the front of
the meter.
International Symbols
1
2
3
4
5
6 7
