EL355 Elliptical
STEP 1: CONSOLE MAST ASSEMBLY
1. Locate the Console Mast (10) and Console Mast Cover (41) and slide the Cover onto the
Mast as far as it will go. Make sure the Console Mast Cover is facing the correct way.
2. At the top opening of the Main Frame (1) there is a Computer Cable (32) attached to a
guiding wire. Unravel the wire and feed the Computer Cable into the bottom of the
Console Mast tube and out of the top opening.
3. Install the Console Mast (10) into the receiving bracket on the top of the Main Frame. Pull
slightly on the computer cable at the top of the mast while installing, this will ensure the
cable does not get pinched and shorted during mast assembly.
4. Install one 3/8" Split Washer (120) and one 3/8 Curved Washer (114) onto one of the
3/8" x 3" Hex Head Bolts (119) and install through the front of the Console Mast; just
hand tighten for now. Install two 3/8 Flat Washers (94) and two 3/8" Split Washers (120)
onto two 3/8" x 3" Hex Head Bolts (119). Install them through the left side of the receiving
bracket into the Console Mast. Now tighten all 3 bolts as tight as possible and snap the
console mast cover into place.
5. There are three connectors at the top opening of the Console Mast; two Hand pulse
wires (37) and one Computer Cable (32). Connect these to the mating connectors on the
back of the Console Assembly (31).
6. Store the excess wiring back into the Console Mast (10) as you carefully install the
Console Assembly (31) onto the mounting plate of Console Mast. Secure the console
with four M5 Phillips Head Screws (78).
Assembly Instructions
FOR EL355
