Po w e r Pr u n e r
TM
oP e r a T o r 's Ma n u a l
17
Automatic Oiling System
1. Wipe debris from around oil ll cap.
2. Remove oil ll cap and ll reservoir with a quality, low viscosity
guide bar and saw chain oil.
NOTE
The discharge volume of the automatic oiler is preset to deliver 3
to 4 cc/min. at normal operating RPM. During heavy or dry cutting
conditions the oil discharge volume may be adjusted to assure ad-
equate lubrication. Rell the oil reservoir with each tank of fuel.
IMPORTANT
To prevent plastic deterioration, do not use synthetic or silicone
based oil.
a d J u s t I n G a u t o m a t I c o I l e r
Tools required: Screwdriver
1. From bottom of gear case, turn adjustment screw (A) clockwise to
decrease oil volume - counter clockwise to increase oil volume.
NOTE
Very little visible oil on the saw chain will provide sufcient lubri-
cation.
l u b r I c a t I n G t h e G u I d e b a r a n d s a W c h a I n
A
