Troubleshooting &
Techn. Support
What to do if you have problems
Version 1.03
4-6
4.1.3 Solutions for NetPorty II
You start PcCANControl but the connection doesn’t
work correct:
For parallel port usage it is necessary to have the
EPP-loader-firmware (BOOTLOAD.H86) in the
NetPorty II -Flash-EPROM. All Porty's are
delivered with this loader!
You have overwrite the delivered EPP-Loader by
your own firmware.
In this case it is possible to download the EPP-
firmware again into the NetPorty II -Flash. This
software is a Win32-Console-Application and
runs under Win95 and WinNT.
How to use:
- Connect your NetPorty II with one serial port.
- If you do not use COM1 please change it into
the file L.BAT.
-Start L.BAT.
If you get an error messages like
"BSL: no response from the target hardware"
it is possible that you have used the wrong
COM port.
- If you get the message below
"-- COMx Loading bootload.h86..Ready"
without any error message in the next line, all
activities are correct finished
- Leave the software with pressing the ESC key,
sometimes Alt X does not work.
Info:
The program LDFSER.EXE is a loader that burns
firmware in the Porty-Flash and also it is a serial monitor
The serial parameter are 115200,8,n,1. I+ME also can
deliver a loader to start firmware in the RAM and a little
firmware demo (Keil-C). Please contact us if you want to
develop your own firmware.
