7
7.2 WATER SUPPLY
• Insure that the water source being used can supply enough water for the demand
of the pump. Use a minimum ¾” hose (19 mm). This unit does not use suction to
pull from a water source. Provide at least 40 PSI (2.8 bar) of clean water
7.3 WATER FILTER INSTALLATION
• NOTE! Use factory-supplied water filter in water supply to the pump.
Contaminants in water can damage pump and plug nozzles if filter is not used!
Drain
IN
Bucket
OUT
Pressure Adjust Pressure Gauge
• Connect the larger water supply line to the CITC filter assembly (mount near the
pump, possibly on frame of a dolly or a wall if permanently installed). Simply
connect the hose onto the filter.
• Before connecting to pump, run water through the hose, then the CITC filter for
thirty seconds to flush the line and avoid any contaminants entering the pump,
then connect the 3-foot long tubing from the filter to the “IN” connection on the
pump.
• If using a new hose, rinse the hose for ½ hour to flush out odors.
7.4 ANTI-DRIP EXTENSION
• The anti-drip feature stops drips from occurring when stopping and starting the
Jungle Mist System Anti-Drip
TM
. Each time you stop the system, the auto-drain
valve removes a slight amount of water to reduce pressure (1/4 cup) to drain into
the bucket supplied. For testing, place a bucket at rear of pump under tube
coming out of the machine in the back marked DRAIN. For permanent installation
run a hose from the DRAIN outlet to a convenient sewer drain.
• When using the anti-drip system, do not install auto-drain valves (not supplied).
(The auto-drain valves, used with the regular Jungle Mist System
TM
, are installed
in line with the nozzles to drain the mist line for protection from freezing damage
when not in use.)
