Installation Instructions XCM1U
9
Adjustments
CAUTION: Watch for pinch points! Do not place fingers
between moveable parts.
Roll
The ceiling mounts allow up to 3° roll each direction.
1. Turn the roll adjustment bolt in the direction necessary for
the desired roll. (See Figure 11)
2. Stop adjusting when the desired setting is reached.
Figure 11
Tilt
The interface brackets allow -5° to 20° tilt, and can be locked at
0°, 10° and 20° tilt.
3. If necessary, loosen button head tilt friction bolt (located on
side of interface bracket). (See Figure 12)
4. Adjust tilt as required. (See Figure 12)
5. The tilt may be locked at 0°, 10° and 20° using one
10-24 x 2-1/4" Phillips head screw (X) and one 10-24 lock
nut (Z) per interface bracket. (See Figure 12)
6. Tighten button head tilt adjustment bolt as necessary.
Figure 12
OPTIONAL: Security
1. OPTIONAL: Add padlock (not included) to each interface
bracket to lock display to ceiling mount. (See Figure 13)
Figure 13
1
Roll
adjustment
bolt
Lock at
Lock at
Lock at
Tilt
friction
bolt
3
4
6
(Displays not shown)
5
(X)
(Z)
0° tilt
10° tilt
20° tilt
Padlock
(Optional)
